The "Pull-out game" of a medical IoT device. Firmware Extraction to a Root shell!
Flash extraction and my problems with the Bus Pirate.First part that drew my attention was the Macronix MX25L12833F Serial Flash and instinctually I grabbed my Bus Pirate v3.6.
Gonna call it a night… For some reason the reading is hanging? Maybe because I’m running this in a VM? I’ll try again tomorrow 😴— Hong's Electronics (@ElectronicsbyJH) September 8, 2021
So things didn't go as planned (expected with any HWRE), I kept finding that there are a lot of issues with flashrom and the Bus Pirate (Open GitHub Issue). Despite getting the "Reading flash..." message in the terminal, the process just hanged. I didn't want to deal with the effort of configuring my Bus Pirate, so I opted to use my Shikra, a FT2232H/FT232H based hardware hacking tool (GitHub and usage instructions) (Flashrom FT2232_SPI page).
Much better luck with the @XipiterSec Shikra (FT232H) 😎 pic.twitter.com/RxmcuE6Fvx— Hong's Electronics (@ElectronicsbyJH) September 9, 2021
Reading with the Shikra, this process took approximately about 5 seconds. While exploring the binary with Ghidra, I also soldered on some wires for access to the UART. Conveniently I can use the Shikra also for UART!
UART access 👍 pic.twitter.com/3hByWnmcjY— Hong's Electronics (@ElectronicsbyJH) September 9, 2021
Gotta get root now!
So, at this point I have a firmware image, and now UART access... do I have root? No, not yet. At this point I played around with U-Boot and set the bootargs to get a root shell, this did not work and I booted into a "nobody" shell, and the passwd/shadow files cannot be read. I'm not exactly a linux/bash expert, and so at the time I thought it was strange that the passwd/shadow files pointed to a /etc path in a JFFS2 filesystem. This turned out to be a crucial detail when I used binwalk later...
The next method I chose to see if I could get the password, was to analyze the firmware image, and this is where binwalk came in handy big time! Of interest was that JFFS2 filesystem, I took a lucky guess and mounted the data from the first JFFS2 partition.
Of interest to me was the JFFS2 filesystem, because I noticed earlier that the passwd and shadow files pointed to a /etc path in a "JFFS2" partition. So after using binwalk to extract the contents of the flash dump, I followed this guide on mounting the JFFS2 filesystem. Some of the modprobe commands don't work, but I still managed to mount the file system anyway. From the mounted partition I then copied the passwd and shadow files and proceeded to use John The Ripper to crack this MD5-crypt hashed password.
Umm... did I use the tool wrong?
“I’m in” pic.twitter.com/2t1syZmgpX— Hong's Electronics (@ElectronicsbyJH) September 9, 2021
I changed the password promptly after getting root, and I noticed that the hash changed... Weird. Okay, so I then proceeded to change the hash, using vim to edit the shadow file, back to the original and now it lets me enter a blank password. I don't know if this is the result of some misconfiguration, or an security by obscurity method.
In my quick write up of extracting a firmware image to getting a root shell, I learned that I can't rely on my Bus Pirate, and that the FT2232H/FT232H chips are quite well supported and very fast! I'm still scratching my head over why the password hashing seems to be "broken"?
Post a Comment